TP-Link Jetstream TL-SL2428P - Configuring MLD Snooping for Vlans

User Guide 232
Configuring Layer 2 Multicast MLD Snooping Configuration
2) Click Apply.
3.1.2 Configuring MLD Snooping for VLANs
Before configuring MLD Snooping for VLANs, set up the VLANs that the router ports and
the member ports are in. For details, please refer to Configuring 802.1Q VLAN.
The switch supports configuring MLD Snooping on a per-VLAN basis. After MLD
Snooping is enabled globally, you also need to enable MLD Snooping and configure the
corresponding parameters for the VLANs that the router ports and the member ports are
in.
Choose the menu
L2 FEATURES > Multicast > MLD Snooping > Global Config,
and click
in your desired VLAN entry in the
MLD VLAN Config
section to load the following page.
Figure 3-2 Configure MLD Snooping for VLAN
Follow these steps to configure MLD Snooping for a specific VLAN:
1) Enable MLD Snooping for the VLAN, and configure the corresponding parameters.
VLAN ID Displays the VLAN ID.
MLD Snooping
Status
Enable or disable MLD Snooping for the VLAN.
Downloaded from ManualsNet.com search engine