User Guide 676
Configuring IPv6 IMPB ND Detection Configuration
3
ND Detection Configuration
To complete ND Detection configuration, follow these steps:
1) Add IPv6-MAC Binding entries.
2) Enable ND Detection.
3) Configure ND Detection on ports.
4) View ND statistics.
3.1 Using the GUI
3.1.1 Adding IPv6-MAC Binding Entries
The ND Detection feature allows the switch to detect the ND packets based on the
binding entries in the IPv6-MAC Binding Table and filter out the illegal ND packets. Before
configuring ND Detection, complete IPv6-MAC Binding configuration. For details, refer to
IPv6-MAC Binding Configuration.
3.1.2 Enabling ND Detection
Choose the menu SECURITY > IPv6 IMPB > ND Detection > Global Config to load the
following page.
Figure 3-1 ND Detection Global Config
Follow these steps to enable ND Detection:
1) In the Global Config section, enable ND Detection and configure the related
parameters. Click Apply.
ND Detection Enable or disable ND Detection globally.
2) In the VLAN Config section, enable ND Detection on the selected VLANs. Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
