Managing MAC Address Table MAC Address Configurations
User Guide 131
Note:
•
In the same VLAN, once an address is configured as a static address, it cannot be set as a
filtering address, and vice versa.
•
Multicast or broadcast addresses cannot be set as static addresses.
•
Ports in LAGs (Link Aggregation Group) are not supported for static address configuration.
2.1.2 Modifying the Aging Time of Dynamic Address Entries
Choose the menu L2 FEATURES > Switching > MAC Address > Dynamic Address to load
the following page.
Figure 2-3 Modifying the Aging Time of Dynamic Address Entries
Follow these steps to modify the aging time of dynamic address entries:
1) In the Aging Config section, enable Auto Aging, and enter your desired length of time.
Auto Aging Enable Auto Aging, then the switch automatically updates the dynamic address
table with the aging mechanism. By default, it is enabled.
Aging Time Set the length of time that a dynamic entry remains in the MAC address table after
the entry is used or updated. The valid values are from 10 to 630 seconds, and the
default value is 300.
A short aging time is applicable to networks where network topology changes
frequently, and a long aging time is applicable to stable networks. We recommend
that you keep the default value if you are unsure about settings in your case.
2) Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General