User Guide 40
Managing System System Info Configurations
2.2.5 Configuring LED
(Only for Certain Devices)
Note:
Only TL-SG2210P supports LED On/Off.
Follow these steps to configure the LED status:
Step 1 configure
Enter global configuration mode.
Step 2 service led {on | off}
Configure the LED status. By default, the LEDs are on.
on | off: Turn on or turn off the LEDs.
2.2.6 Configuring the System IP
Follow these steps to configure the System IP parameters.
Step 1 configure
Enter global configuration mode.
Step 2 ip management-vlan {
vlan-id
}
Configure the management VLAN of the switch. Only the computers in the management
VLAN can access the management interface of the switch.
Step 3 interface vlan {
vlan-id
}
Enter the Interface VLAN Mode.
vlan-id:
The management VLAN ID.
Step 4 Automatically assign an IP Address and default gateway for the management interface via
DHCP or BOOTP:
ip address-alloc { dhcp | bootp }
Specify the IP Address assignment mode of the management interface.
dhcp: Specify the management interface to obtain an IPv4 address from the DHCP Server.
bootp: Specify the management interface to obtain an IPv4 address from the BOOTP
Server.
Manually assign an IP Address and default gateway for the management interface:
ip address {
ip-addr
} {
mask
} gateway {
default-gateway
}
Configure the IP address and default gateway for the management interface manually.
ip-addr
: Specify thse IP address of the management interface.
mask
: Specify the subnet mask of the management interface.
default gateway
: Specify the default gateway of the management interface if you select
the IP Address Mode as Static. The default gateway is the IP address to which the packet
should be sent next.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
