User Guide 686
Configuring IPv6 IMPB Configuration Examples
Figure 5-3 Binding Entry for User 2
3) Choose the menu SECURITY > IPv6 IMBP > ND Detection > Global Config to load the
following page. Enable ND Detection and click Apply. Select VLAN 1, change Status as
Enabled and click Apply.
Figure 5-4 Enable ND Detection
4) Choose the menu SECURITY > IPv6 IMBP > ND Detection > Port Config to load the
following page. By default, all ports are enabled with ND Detection. Since port 1/0/3 is
connected to the gateway router, configure port 1/0/3 as trusted port. Click Apply.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
