©2021 TP-Link 7106509168 REV1.0.0
Contact
Sensor
Quick Start Guide
Before You Start
A Tapo Hub is required. Make sure your
Tapo Hub is successfully added via the
Tapo app.
OR
1. Power Up Your Sensor
a. Use a screwdriver to tilt the clip (not pry) and
slide the cover down by hand.
b. Remove the battery insulation tab to power
up your Tapo device.
Meet Your Contact Sensor
Know when doors and windows are opened or closed and send you intant alerts via the Tapo app. Open the Tapo app, tap the button in the
app, and select your model. Follow app
instructions to complete the setup.
2. Set Up Your Sensor
Battery Compartment
Remove the battery
insulation tab before use.
Reset Button
LED Light
Sensor
Magnet
Magnet
Alignment
Mark
To Next Page
Need help?
General
