Warning Before Installation
1
MODEL NO. TL-SC4171G
Physical Description
2
Package Contents
System Requirement
QIGResource CD
Wireless Pan/Tilt Surveillance Camera
• Do not keep the
Camera exposed to
direct sunlight.
• Do not place the
Camera in high humidity
environments such as
in a kitchen.
• Do not place the
Camera where there are
sharp temperatures such as
near an oven.
• Do not place the camera
near devices that emit
radio waves, such as
mobile phones.
D escription
t
• Solid: The electrical power is on.
• Off: There is no electrical power.
• Solid: The Ethernet port is linked, but there is no activity.
• Blinking: There is traffic between the Ethernet port and
the network.
• Off: There is no Ethernet connection.
MODEL NO. TL-SC4171G
Camera Mounting Bracket Power Adapter
The following operating systems are supported:
The following browsers are supported:
• Windows XP • Windows Vista • Windows 7
• Windows 98 • Windows 2000 • Windows 2003
• Windows Me • Mac • Linux
• Microsoft Internet Explorer • FireFox
• Safari • Chrome
Ethernet Cable
Quick Installation Guide
Hardware Connection
4
Router
Internet
WAN LAN
1 2 3
NOTE: Before proceeding, conrm that your PC is connected
to your router and can access the Internet. Also conrm that
your router’s DHCP feature is enabled. (Most routers have
DHCP turned on by default.) For detailed information, please
refer to the operation instructions included with your router.
Camera Mounting
3
Antenna Connector
Audio Out
Reset Button
General I/O Terminal Block
Power Connector
Audio In
Network Connector
Power LED
Ethernet LED
Built-in Microphone
Ceiling Mount Wall Mount
1
2
1
2
Fix the camera to the bracket
with two type A screws .
Fix the bracket and camera
to the ceiling using two
type B screws and two
hollow ceiling anchors.
Fix the bracket to the wall
using two type B screws and
two hollow wall anchors.
Fix the camera to the bracket
with two type A screws .
12V DC
Audio in
Audio out
Ethernet
I/O
reset
12V DC
Audio in
Audio out
Ethernet
I/O
reset
Reset Button
Bracket
Type A screws Type B screws
Hollow anchors
NOTE: In the bracket, there are several mounting holes arranged in a circle. The direction of the camera’s
installation can be anywhere within a 360 degree scope, adjusted as required.
It is strongly recommended that you connect the Ethernet cable and power adapter cord to the camera rst
before mounting.
Item
Power LED
Ethernet LED
• Step 1: Re-power on the camera and wait for at least 45s
until it restarts up normally.
• Step 2: Press the button for more than 10s, then it will be
restored to factory defaults after automatic rebooting.
7106503435
Power Cable
Wireless Pan/Tilt Surveillance Camera
Quick Installation Guide
Ethernet Cable
(*The pictures are for reference only.)
To Next Page
