Now the router really, really has to reboot. We’re not going to be able to connect to it again until
it’s functioning as the XSCE’s AP. But that’s it for the initial configuration.
Wait a minute or so for the router to reboot, then unplug the power and wait a couple of minutes.
Plug it back in. Connect an ethernet cable to a LAN port on the router and connect a USB
ethernet adaptor to the other end of the cable. During the XSCE install instructions, when it tells
you to insert a USB ethernet adaptor into the XSCE, you’re ready to go.
Don’t forget to unplug the ethernet cable from your computer to the router, then connect your
computer back to your usual connection.
Security settings and other concerns
To Next Page
Loading...
