Configuring TP Link TL-WR802N
If reconfiguring device start at step 1.
If configuring for the first time, plug in device and skip to step 2.
1. Insert a paperclip into the small hole on the device and hold down button until green light starts
flashing quickly (about 10 seconds). This resets device to its factory settings.
2. After the device boots up, search for wireless networks on your laptop or smart phone. There
may be delay for the network to appear after start up.
3. Connect to TP-Link Network. The password is written on the device.
4. Open a browser and enter tplinkwifi.net or 192.168.0.1 in the address field
5. Enter the word admin (lowercase) in both the username and password fields. Click OK.
6. Choose “Quick Setup” on left, then click Next.
7. Choose Client mode and click Next.
To Next Page
