2
WAN: Flashing or solid light
Turn on all of your network devices and then check to see if the LEDs of the
Router display normally as the digram below describes.
Note
To configure the device, you can either run the Resource CD (method one),
or run the Web-based Quick Setup Wizard (method two). TP-LINK strongly
recommends that you run the Resource CD.
LAN: Flashing or solid light if the
corresponding port is connected
Note
If the LEDs display abnormally, please check to see if all the cable
connectors (power adapter and Ethernet cable) are well connected to you
To Next Page
Loading...
