To Next PageTo Next Page
Need help?Do you have a question about the TPI KFR-26GW/ZBP and is the answer not in the manual?
General| Brand | TPI |
|---|---|
| Model | KFR-26GW/ZBP |
| Category | Air Conditioner |
| Language | English |
Lists and identifies components of the indoor unit.
Provides the physical measurements of the indoor unit.
Details the required space and hole placements for installation.
Presents the physical dimensions for the outdoor unit.
Illustrates the refrigeration cycle for cooling-only configurations.
Depicts the refrigeration cycle for units with both cooling and heating.
Covers frequency control, temperature limits, and ice avoidance in cooling mode.
Details indoor and outdoor temperature influence on system operation.
Outlines conditions for cooling system overload protection.
Explains automatic frequency adjustment for soft/dry modes.
Details frequency control and conditions for heating mode.
Explains conditions for heating system overload protection.
Describes how the system prevents cold air discharge during heating.
Illustrates the timing and sequence of defrost operations.
Explains automatic mode selection based on temperature settings.
Describes the sleep mode operation and temperature adjustments.
Explains how discharge temperature affects system frequency and operation.
Details the mandatory 3-minute delay before compressor restart.
Describes how low voltage impacts operating frequency.
Shows cooling frequency control based on voltage.
Explains current limits and their effect on system operation.
Details conditions for IPM protection and compressor shutdown.
Illustrates the electrical connections within the indoor unit.
Shows the electrical wiring for the outdoor unit components.
Lists all replaceable parts for the indoor unit.
Provides a catalog of replaceable parts for the outdoor unit.
Explains fault indication methods for V, E, and F type units.
Maps indoor LED states to specific fault conditions.
Lists faults based on yellow/green LED blinking for E type.
Lists faults based on green LED blinking for F type.
Describes meanings of LED4 on/off/blinking states.
Provides steps for reclaiming and adding refrigerant.
Identifies issues related to electrical open circuits.
Explains reasons and solutions for compressor startup failure.
Covers faults in remote control signal communication.
Outlines causes and solutions for compressor not moving.
Addresses issues with the indoor fan failing to operate.
Explains why the outdoor fan might not be working.
Diagnoses and resolves 4-way valve issues in heating.
Covers causes of high compressor temperature.
Details problems related to temperature sensors.
Lists electrical components for the indoor unit.
Lists mechanical and structural components for the indoor unit.
Lists additional mechanical parts for the indoor unit.
Lists parts related to the refrigerant cycle of the indoor unit.
Lists electrical components for the outdoor unit.
Lists mechanical and structural components for the outdoor unit.
Lists additional mechanical parts for the outdoor unit.
Lists parts related to the refrigerant cycle of the outdoor unit.
Lists additional mechanical parts for the outdoor unit.
Lists various valve components for the outdoor unit.
Lists printing-related items for the outdoor unit.
