Need help?Do you have a question about the TRACE ELLIOT AH600-12 and is the answer not in the manual?
Details the layout and differences of the front panels for 7 and 12 Band models.
Describes the input jack and the HI/LO sensitivity switch.
Explains setting the INPUT GAIN and interpreting the signal level LEDs.
Details the tuner output and the classic 'Mid Pre-Shape' tone circuit.
Explains the VALVE switch, DRIVE, and BLEND rotary controls for the 12 Band model.
Describes the DI OUT socket and the PRE/POST signal selection for the 7 Band.
Details the operation and capabilities of the graphic equalizer.
Explains the 7 Band compressor switch, control, and its effects on dynamics.
Adjusts compression for the low frequencies in the signal.
Adjusts compression for the high frequencies in the signal.
Explains the soft-knee, adaptive attack/release, and uses of the dual band compressor.
Details the SEND and RETURN sockets for the 7 Band effects loop.
Explains the MUTE switch and the OUTPUT LEVEL rotary control.
Describes the various functions of the red LED above the OUTPUT LEVEL control.
Details the unbalanced LINE OUT socket for signal output on the 7 Band.
Details the 8-pin DIN socket for connecting the footcontroller.
Explains the DI EARTH LIFT switch for preventing ground loop hum.
Details SEND, SERIES/PARALLEL switch, and RETURN sockets for the 12 Band.
Sets the overall signal level for the effects loop when active.
Provides examples for using effects loops for various sonic enhancements.
Details the buffered tuner output for the 12 Band model.
Describes PRE EQ, LEFT, and RIGHT DI outputs for the 12 Band.
Details unbalanced 1/4" jack outputs for expanding the system.
Explains Speakon and 1/4" jack speaker output connections and safety.
Adjusts the brightness of the front panel backlighting.
Details the power switch operation and the IEC socket with fuse holder.
Details the high efficiency advanced power amplifier design and protection features.
Explains the two-stage circuit preventing amplifier clipping and speaker damage.
Describes various combo preamp, power amp, and speaker configurations.
Provides a guide to diagnosing and resolving common operational problems.
Recommended settings for a classic Trace Elliot tone with pre-shape and low compression.
Settings for boosted lows with rolled-off highs.
Recommended settings for a compressed, punchy funk sound.
Settings for a warm, vintage tone using valve drive.
Settings for valve and graphic EQ with low compression.
Settings for pre-shape, valve, graphic EQ, and compression.
Provides physical dimensions and weight for various combo models.
General| EQ Bands | 12-band Graphic EQ |
|---|---|
| Effects Loop | Yes |
| Power Output | 600W |
| Impedance | 4 Ohms |
| DI Output | Balanced XLR DI Out |
| Speaker Outputs | 2 x Speakon |
| Footswitch Jack | Yes |
| Dimensions | 19" |
| Weight | 44 lbs |
To Next Page