Installation Instructions - General Information Issue: 1.0
TRACKER Network (UK) Ltd Date: 01/07/2013
TRACKER Technical Support
General Information
(Read the following carefully before proceeding with installation)
1.1 Scope
This document describes the TRACKER Plus installation requirements of the specified vehicle.
This document MUST be used in conjunction with the other relevant TRACKER Operational
Procedures listed below.
1.2 Other References
TRACKER OP60 TRACKER SVR Installation Standards
TRACKER OP66 TRACKER Retrieve/Monitor Product Information
TRACKER OP67 TRACKER Locate Product Information
TRACKER OP68 TRACKER Locate/Plant VLU6R Commissioning
TRACKER OP85 TRACKER Dealer Portal Installer User Guide
TRACKER OP86 TRACKER Dealer Portal Sales Administrator User Guide
TRACKER TB TRACKER Technical Bulletins
1.3 Definitions
EWD Electrical Wiring Diagrams
GPS Global Positioning System
LED Light Emitting Diode
QA Quality Audit
TIS Technical Information Service
TRACKER TRACKER Network (UK) Ltd
VHF Very High Frequency
VLU Vehicle Location Unit
1.4 Holes drilled into the vehicle
Any holes drilled into the vehicle must be treated with anti-corrosion paint.
1.5 Lexus approved TRACKER units
Only approved Lexus supplied TRACKER units can be used
1.5 Airbag safety precautions
Ensure Airbag safety instructions are followed as per the Workshop Manual.
1.6 Hybrid safety precautions
Ensure Hybrid vehicle safety instructions are followed as per the Workshop Manual.
1.7 Connections to the vehicle
All connections to the vehicle MUST be made using the Lexus approved connection method as
described in TIS. Please check all connection points with the EWD for the latest wiring
information.
To Next Page
Loading...