EasyManua.ls Logo

trackit VT10 - GSM Antenna Mounting Guidelines; Device Inputs and Outputs Overview; Customer Battery Maintenance Advisory

Default Icon
14 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-4- TrackIt Limited V 7.5 April 2013
dashboard brackets etc).
Located as high as possible without being obvious.
Kept away from AM/FM radio antenna. To avoid interference do not run the
GPS/GSM antenna wiring along or over the AM/FM radio.
Do not tie antennas with power loom if this cannot be avoided, thread 1 x ferrite
sleeve through red power loom. The ferrite sleeve works on eliminating
interference especially with older radios.
ANTENNA MOUNTING (GSM)
9. When mounting the GSM antenna the following points should be taken into consideration.
The GSM antenna should be:
Ideally mounted at the base of the windscreen for maximum GSM reception.
However, if an installation is covert and must be hidden the following should be
taken into consideration:
Make sure the unit is already connected to GSM network (Green LED flashes 0.1
second on and 2.9 seconds off). Green LED stays 1 second on and 2 seconds off
(can’t get GSM signal) after the unit is turned on.
It must not have any metal covering the antenna or directly above it (pillars, roof,
dashboard brackets etc).
Located as high as possible without being obvious.
Kept away from AM/FM radio antenna to avoid interference.
Do not tie antennas with power loom if this cannot be avoided, thread 1 x ferrite
sleeve through red power loom. The ferrite sleeve works on eliminating
interference especially with older radios.
INPUTS/OUTPUTS
10. The inputs/outputs on the device MUST comply with the following standards:
INPUT 1: SOS button (already wired)
INPUT 2: Crash sensor (optional)
INPUT 3: Car Alarm (optional)
INPUT 4: Ignition (MANDATORY)
INPUT 5: Door Sensor (optional)
OUTPUT 1: If a relay switch is being installed it MUST be wired to thisoutput to
immobilize the vehicle.
Once the device has been installed, please call (0508) TRACKIT and quote the D: number recorded on
box. We can then complete the setup and confirm the unit is functioning correctly.
PLEASE NOTE: (AND ADVISE YOUR CUSTOMERS)
This device will draw a small amount of current which over a period of time will discharge your battery
if the vehicle has prolonged periods of not being used. We strongly recommend that you attach a trickle
charger to your vehicle whilst it is in storage to prevent your battery from being drained.