2
Table of Contents
Disclaimer 4
Preface 5
1. Safety and compliance 6
1.1 Safety Notices 6
1.2 Hazards 6
2. Introduction 8
2.1 Main components 8
2.2 Specifications T1250 8
2.3 Specifications T850 10
2.4 Specifications T650 11
3. Unboxing 13
4. Setup for rst use 13
4.1 Set up network 13
4.2 Update the firmware 16
4.3 Calibrating the print bed 17
4.4 Installing slicing software 18
4.5 Uploading files to 3D printer 24
5. Operation 25
5.1 Web interface 25
6. Materials 30
6.1 Material compatibility 30
6.2 Print recommendations 31
6.3 Tips for experimental materials 32
7. Operating the 3D printer 33
7.1 Load material 33
7.2 Unload material 35
7.3 Removing the filament with a blob 36
To Next Page
Loading...
