2
Table of Contents
Disclaimer 4
Preface 5
1. Safety and compliance 6
1.1 Safety Notices 6
1.2 Hazards 6
2. Introduction 8
2.1 Main components 8
2.2 Specifications T3500 8
2.3 Specifications T3000 10
3. Unboxing 12
4. Setup for rst use 12
4.1 Set up network 12
4.2 Update the firmware 15
4.3 Calibrating the print bed 16
4.4 Installing slicing software 19
4.5 Uploading files to 3D printer 25
5. Operation 26
5.1 Web interface 26
6. Materials 31
6.1 Material compatibility 31
6.2 Print recommendations 32
6.3 Tips for experimental materials 33
7. Operating the 3D printer 34
7.1 Load material 34
7.2 Unload material 37
7.3 Removing the filament with a blob 38
7.4 Preparing your print bed 40
To Next Page
Loading...
