KVH, TracVision, and the unique light-colored dome with contrasting baseplate are registered trademarks of KVH Industries, Inc.
All other trademarks are property of their respective companies. The information in this document is subject to change without notice.
No company shall be liable for errors contained herein. © 2008 KVH Industries, Inc., All rights reserved. 54-0532 Rev. A
1
These instructions explain how to replace an elevation motor and/or elevation motor belt in a
TracVision M9 antenna.
Installation Steps
Tools Required
This procedure requires the following tools:
Technical Support
If you need technical assistance, please contact KVH Technical Support:
1. Remove the Radome, 2
2. Mark the Current Belt Tension, 2
3. Remove the Belt, 3
4. Remove and Replace the Elevation
Motor (if required), 3
5. Replace the Belt, 3
6. Set the Belt Tension, 4
• Phillips screwdrivers
• Tension meter (30 lb/13.06 Kg or
greater)
• Needle-nose pliers
•Scribe or pencil
N. America, S. America, Australia:
Phone: +1 401 847-3327
E-mail: techs@kvh.com
Europe, Middle East, Asia:
Phone: +45 45 160 180
E-mail: support@kvh.dk
Elevation Motor/Belt Replacement
Instructions for TracVision
®
M9
To Next Page
Need help?
General
