TradePro TP-N-511 - User Manual

This thermostat requires 24 Volt AC Power or two (2) properly installed
“AA” Alkaline batteries for proper operation. When connecting 24 Volt
AC Power the batteries may be installed as a backup. Thermostat
installation and all components of the system shall conform to
Class II Circuits per NEC code.
For use only as described in this manual. Any other use will void warranty.
TP-N-511
Single Stage Heat / Cool
Conventional and Heat Pump
1 Specifications
2 Installation
3 Setting User Options
4
Operating Your Thermostat
5 Additional Operation Features
6 Thermostat Maintenance
Warning
Turn off power to the heating or cooling
equipment before installation.
Attention
For installation by experienced service
technicians only.
TP-N-521
Up to 2 Heat / 1 Cool
Conventional and Heat Pump
Read all instructions before proceeding.
This thermostat is compatible with:
• Single stage heat / cool conventional and heat pump systems
• Conventional systems up to 2 heat / 1 cool (TP-N-521)
• Single compressor heat pump systems with an auxiliary heat stage (TP-N-521)
• 250 – 750 millivolt heat only systems
Electrical and control specifications:
• Electrical Rating: 24 Volt AC
• 1 amp maximum load per terminal
• AC Power: 18 – 30 Volts AC
• DC Power: 3.0 Volt DC (2 “AA” Alkaline Batteries Included)
• Control Range: 45° – 90° F (7° – 32° C)
• Temperature Accuracy: +/- 1° F (+/- .5° C)
Terminations
• TP-N-511 – Rc, Rh, O, B, Y1, W1, G, C
• TP-N-521 – Rc, Rh, O, B, Y1, E/W1, G, W2, C
1
Specifications
TPN-100-01
Non-Programmable Thermostats
User
Manual
Model number is located on
back of thermostat
®

Summary

Specifications

Installation

Thermostat Location

Choosing an optimal installation spot for good air circulation and average room temperature.

Install the Sub-Base

Mounting the thermostat sub-base to the wall using pilot holes and anchors.

Provide Power

Connecting 24 Volt AC power or installing backup batteries for operation.

Connect Your Wires

Wiring configurations for conventional and heat pump systems.

Set Installer Switches

Configuring system type, temperature scale, and heat source via installer switches.

Attach Thermostat to Sub-Base

Physically connecting the thermostat body to the installed sub-base.

Setting User Options

Advanced User Options

Customizing thermostat features like temperature differential settings.

Operating Your Thermostat

Setting the System Control Mode

Selecting system operation modes like COOL, OFF, HEAT, or EMER.

Setting the Fan Control Mode

Choosing fan operation between AUTO and ON modes.

Temperature Adjustment

Adjusting the current set point temperature using adjustment buttons.

Status Indicators

Interpreting display icons for heating, cooling, or auxiliary/emergency status.

Additional Operation Features

Compressor Protection

Automatic delay feature to prevent short cycling damage to the compressor.

Thermostat Maintenance

Changing the Batteries

Instructions for replacing low or depleted AA batteries.

Thermostat Cleaning

Guidance on cleaning the thermostat exterior with a damp cloth.

TradePro TP-N-511 Specifications

General

Brand	TradePro
Model	TP-N-511
Category	Thermostat
Language	English