To Next PageTo Next PageWhat to do if my Tradesman Saw will not start?
If your Tradesman Saw won't start, it could be due to several reasons: * The saw might not be plugged in, so ensure it is properly connected to a power source. * A fuse may have blown, or a circuit breaker tripped; in this case, replace the fuse or reset the circuit breaker. * The cord could be damaged, requiring replacement by a qualified electrician.
Why does my Tradesman Saw make unsatisfactory cuts?
Unsatisfactory cuts from your Tradesman Saw can stem from several issues: * The blade may be dull, necessitating a replacement. * The blade could be mounted backward; turn it around to correct this. * Gum or pitch accumulation on the blade can cause problems; clean it with turpentine and coarse steel wool. * Using the incorrect blade for the task at hand can also lead to poor cuts; change to the appropriate blade. * Gum or pitch on the table might cause erratic feed; clean the table with turpentine and coarse steel wool, then apply a coat of automotive wax.
What to do if material pinches blade when ripping on Tradesman BTS10BW Saw?
If the material pinches the blade during ripping with your Tradesman Saw, it could be because: * The rip fence is not aligned with the blade; check and adjust its alignment. * The wood may be warped, with an edge that isn't straight against the fence; select a different, straighter piece of wood.
How to fix inaccurate 45 or 90 degree rip cuts on Tradesman BTS10BW Saw?
If your Tradesman Saw isn't making accurate 45 or 90 degree rip cuts, consider the following: * The positive stop may not be adjusted correctly; check the blade with a square and adjust the positive stop accordingly. * The blade tilt pointer might not be set correctly; check the blade with a square and adjust the pointer to zero. * The fence may not be properly aligned; align the rip fence with the miter gauge slot.
Details about connecting the table saw to a suitable power source for safe operation.
Guidance on selecting and using appropriate extension cords for safe operation.
Explanation of proper grounding procedures to reduce the risk of electric shock.
Step-by-step instructions for assembling the table saw stand using provided parts.
Procedure for securely mounting the table saw unit onto its assembled stand.
Detailed steps for securely attaching the table saw to the stand.
Instructions for attaching the handwheel assembly for blade height and tilt adjustments.
Steps to assemble and attach the rip fence mechanism to the table saw.
Procedure for installing the saw blade onto the arbor shaft.
Instructions for assembling and installing the blade guard and splitter components.
Steps to check and adjust the miter gauge for accurate cuts.
General
