Why does my Tradesman M2501LW Saw blade bind, jam, or burn wood?
The Tradesman Saw blade might bind, jam, or burn wood due to several reasons: * Improper operation. * Dull blade: Replace or sharpen the blade. * Improper blade size: Replace it with a 10-inch diameter blade. * Warped blade: Replace the blade.
What to do if my Tradesman M2501LW vibrates or shakes?
If your Tradesman Saw vibrates or shakes, consider the following: * The saw blade may not be round, is damaged or warped: Replace the blade. * The saw blade might be loose: Tighten the arbor screw.
What to do if the Tradesman M2501LW motor does not start?
If the motor of your Tradesman Saw doesn't start: * Check the fuse: Use & check a 15-Amp time delay fuse, or circuit breaker. * The brush might be worn.
How to fix a Tradesman M2501LW Saw when the brake does not stop the blade within 6 seconds?
If the brake on your Tradesman Saw doesn't stop the blade within 6 seconds: * Inspect, clean, or replace the motor brushes if they are not sealed or are lightly sticking. * Ensure you are using a recommended blade and allow the motor brake to cool down if it has overheated due to a defective or wrong-size blade, or rapid ON/OFF cycling. * Retighten the arbor bolt if it is loose.
Why is the angle of cut not accurate on my Tradesman Saw and I can’t adjust the miter?
If the angle of cut is not accurate and you can’t adjust the miter on your Tradesman Saw: * Ensure the miter table is not locked: Push the positive stop locking lever down and rotate the table. * Remove any sawdust under the table by vacuuming or blowing it out, while wearing eye protection.
What to do if the cutting arm wobbles on my Tradesman M2501LW?
If the cutting arm wobbles on your Tradesman Saw, it might be due to loose pivot points.
What to do if the cutting arm won’t fully raise, or the blade guard won’t fully close on my Tradesman M2501LW?
If the cutting arm won’t fully raise, or the blade guard won’t fully close on your Tradesman Saw: * Clean and lubricate moving parts if the pivot spring was not replaced properly after service. * Clean and lubricate moving parts to address sawdust build-up.
Why is there excessive brush spark when the switch is released on my Tradesman M2501LW Saw?
If there is excessive brush spark when the switch is released on your Tradesman Saw, replace the brushes.
Essential PPE including eye protection, face/dust masks, and proper apparel.
Procedures for securing work, disconnecting power, avoiding hazards, and maintenance.
Safety rules for blade types, installation, condition, and usage to prevent injury.
Procedures for safe operation, workpiece handling, maintenance, and damage checks.
Guidelines for connecting to a 120V, 15 Amp circuit with proper fuse or breaker protection.
Crucial safety instructions for handling and using carbide-tipped saw blades to prevent damage or injury.
Detailed instructions for safely removing and installing the saw blade.
Instructions for installing the blade and crucial safety checks for cover plate, collars, and arbor bolt.
Guides for squaring the fence and adjusting the miter scale for precise angle settings.
Crucial safety instructions to follow before and during basic saw operations.
Checklist for pre-use inspection, accessory use, work area, and tool familiarization.
Proper hand/body positioning, blade brake function, and turning the saw on.
Identifies and provides solutions for common motor issues like non-starting or brake problems.
Addresses operational problems such as blade alignment, angle inaccuracy, and binding.
To Next Page
General
