11
square inch) prior to use. Do not use the device if the res are damaged due to its failure to hold air.
Check re pressure before using the Trailer Valet for the first me, since air pressure might have been
lost in transit.
Operating Instructions
In this guide, you are shown the basic
fundamentals
use of your Trailer Valet. Knowing the
proper dollying techniques can help keep
you and others around you safe. Apply
your knowledge of your Trailer Valet and
the basic
Using the Trailer Valet
Step 1: SECURE THE TRAILER VALET
Mount the Trailer Valet onto the moun ng
bracket, drop
Step 2: RAISE THE TRAILER VALET
Remove the rota on pin (Part Number 23)
from the bo om of the jack and turn the
crank (Part Number 3) to raise the trailer up
off the hitch ball, if a ached to a towing
vehicle.
NOTE: Some hitching mechanisms can
become stuck to the ball. Slightly rocking the
trailer will loosen the
are aware of the stability of the load.
Raise the trailer gradually un l the exis ng jack is
above ground (during first use and un l you ar
comfortable with using the Trailer Valet) and
the trailer is completely supported by the
Trailer Valet.
NOTE: Keeping the trailer jack close to the
ground prevents serious damages from occuring
due to unexpected failures.
unable to hold the weight, lower the jack and
remove the device to check air pressure.
Step 4: MOVE THE TOWING VEHICLE
Once the hitch ball of the towing vehicle is
detached from the trailer coupler and the
Trailer Valet fully hoists the trailer, move the
towing vehicle away from the trailer.
NOTE: Driving the Trailer Valet with the jack
extended will cause excessive wear on the jack
and possibly result in injury, and/or property
To Next Page
Loading...