Need help?Do you have a question about the TRAMEX cmeXpert 2 and is the answer not in the manual?
General| Type | Non-destructive moisture meter |
|---|---|
| Resolution | 0.1% |
| Operating Temperature | 0°C to 50°C |
| Measurement Range (WME) | 0 to 100% |
| Display | Digital |
| Power Supply | Battery |
| Storage Temperature | -10°C to 50°C |
| Dimensions | 160mm x 85mm x 38mm |
Explains the principle of operation for concrete moisture measurement mode.
Lists the three measurement modes: Non-destructive, hygrometer, and wood pin probe.
Describes the functions of the six keypad buttons for instrument operation.
Instructions for adjusting the backlight display duration.
Instructions for changing the instrument's display language.
Explains the HOLD function to freeze readings.
Explains readings on the Concrete scale (0-6.9% MC).
Describes the CM Equivalent scale (0-5) for concrete.
Details the Gypsum scale (0-12 comparative) for screeds.
Explains the Reference scale (0-99) for comparative testing.
Shows examples of typical instrument displays for moisture measurement.
Details requirements for accurate moisture testing of floor slabs.
Guidelines for preparing floor slabs and removing coverings before testing.
Step-by-step procedure for conducting moisture tests according to ASTM F 2659.
Lists applications for humidity measurement, like HVAC and building monitoring.
Shows an example display for humidity measurement.
Describes methods (in-situ, RH hood) for measuring relative humidity in flooring.
Detailed procedure for in-situ RH testing using CMEX and RH probe.
Detailed procedure for RH hood testing using CMEX and RH probe.
Step-by-step guide to performing an RH probe calibration check.
Example display for wood moisture content measurement.
Explains how wood species affect moisture meter readings.
Details how wood temperature impacts moisture readings.
Discusses how chemical treatments affect readings.
Explains the effect of surface moisture on readings.
Covers calibration tests and acceptable moisture levels.
Covers interior, exterior, saturation point, treatment, and stack storage.
Illustrates how to use the temperature adjustment chart.
Shows how to combine species and temperature corrections.
Table relating relative humidity to equilibrium moisture content.
Lists limitations of the CMEX, such as not measuring through conductive materials.
States Tramex's policy on product improvement and design changes.
Instructions for returning defective products for warranty claims.
To Next Page
