Tranberg TEF 2650 - User Manual

R. Stahl Tranberg AS
E info@stahl-tranberg.com | stahl-tranberg.com
Main office: Strandsvingen 6 | N-4032 Stavanger | Norway | T +47 51 57 89 00 | F +47 51 57 89 50
Office Oslo: Luhrtoppen 2 | N-1470 Lørenskog | Norway | T +47 24 08 44 10
IMPORTANT
Please read this manual carefully before installing the
product.
SEARCHLIGHTS
TEF 2650/2655 COMMANDER
SEARCHLIGHT HALOGEN & HRI
SAFE AREA
USER MANUAL
Subject to change without prior notice TUM1094 REV. G 28.01.2019

Summary

Safety Instructions

Important Safety Precautions

Important safety precautions for operating the searchlight.

General Warranty Certificate

Warranty Terms and Conditions

Details on the warranty terms and conditions for Tranberg products.

1. System Overview

Searchlight Motion Control

Explains how searchlights move and their positional sensors.

Types of Searchlights and Light Sources

Describes available light sources: Halogen, Xenon, and HRI.

2. Operation

2.1 Start-Up Procedure

Step-by-step guide for powering up the searchlights and panels.

2.2 Control Panel Functions

Overview of the multi-searchlight control panel and its buttons.

3. Maintenance

3.1 Cleaning and Lubrication

Procedures for cleaning panels and searchlights, and lubrication intervals.

3.3 Mechanical Checks

How to check mechanical parts and tighten screws.

4. Installation

4.1 Mechanical Installation

Details on physical placement and mounting of searchlights.

4.2 Electrical Installation - Cabling

Covers communication network setup and electrical connections.

4.3 Electrical Installation - Settings

Details on setting addresses for panels and searchlights.

4.4 System Startup Procedure

Steps for powering up the searchlight system correctly.

5. Special Procedures

5.1 Identifying the Master Panel

How to identify the main control panel in the system.

5.2 Bus Node Re-Scan Procedures

Steps for re-scanning connected nodes on the communication bus.

5.4 Searchlight Reset and Recalibration

Procedures for resetting searchlights and recalibrating end limits.

5.6 Changing Searchlight Address

Method for changing the address of a searchlight unit.

6. Fault Finding

6.1 General Troubleshooting Principles

General advice for diagnosing system-wide or specific faults.

6.2 Problems with Movement

Common issues and solutions related to searchlight movement.

6.3 Lamp On;Off Faults

Troubleshooting steps for issues with the lamp not turning on or off.

6.4 Panel Related Problems

Diagnosing faults occurring on control panels.

6.5 Installation Problems

Common issues encountered during system installation.

7. Connections, Settings, and Indicators

7.1 Panel Types and Connections

Details on panel models, screw terminal and RJ-45 connections.

Panel Settings and Rotary Switch Configuration

How to set panel addresses, modes, and types using rotary switches.

Panel and Module Indicators

Explains status LEDs for panels, motor units, and control modules.

7.2 Searchlight Motor Unit Versions

Describes the two versions of the motor unit, their connections, DIP switches, and address settings.

7.3 Control Module Status Signals

Explains status indicators for SIM and RCM control modules.

8. Technical Data

Searchlight Specifications

Detailed technical specifications for various searchlight models.

Optical System and Motion Data

Details on lamp power, lifetime, divergence, range, and motor movement.

Panel Specifications

Technical data for the control panels (dimensions, electrical, operating temperature).

Tranberg TEF 2650 Specifications

General

Lamp Type	LED
Ingress Protection	IP66/67
Beam Angle	120°
Lens Material	Polycarbonate
Material	Aluminum
Mounting	Surface
Application	Marine Lighting
Voltage	24V DC
Color Temperature	5000K
Operating Temperature	-25°C to +55°C
Housing Material	Aluminum