To Next PageTo Next Page
Need help?Do you have a question about the Trane AUH1B060A9361A and is the answer not in the manual?
General| Model | AUH1B060A9361A |
|---|---|
| Category | Furnace |
| Heating Capacity | 60, 000 BTU |
| Airflow | 1, 200 CFM |
| Phase | 1 |
| Hertz | 60 Hz |
| Width | 17.5 inches |
| Blower Type | Multi-Speed |
| Ignition Type | Hot Surface Ignition |
| Heat Exchanger Material | Aluminized Steel |
| Input BTU | 60000 BTU/hr |
| Fuel Type | Natural Gas |
General safety practices and precautions for furnace installation and operation.
Critical steps to prevent carbon monoxide poisoning during venting system operation.
Manufacturer responsibilities, code compliance, and initial site inspection guidelines.
Guidelines for selecting furnace location and maintaining required clearances for safety and service.
Outline drawings and dimensional data for UH1 furnace models.
Outline drawings and dimensional data for DH1 furnace models.
Guidelines for horizontal installation and condensate drain connections.
Requirements for providing adequate air for combustion and ventilation to ensure safe operation.
Guidelines for connecting air duct systems to the furnace for proper airflow and noise reduction.
Instructions for installing return air filters and filter racks on upflow furnaces.
Requirements for direct/nondirect venting, pipe materials, lengths, and clearances.
Field wiring diagrams, electrical connections, and twinning setup for furnace operation.
Rules and regulations for installing gas piping, including joint compound and shut-off valves.
Procedures for checking combustion and input rate, including gas flow and orifice checks.
Procedures for derating furnace input for installations at high altitudes above sea level.
Preliminary inspections, lighting instructions, and burner box cover reinstallation.
Explanation of furnace operation sequence, safety switches, and control module functions.
Troubleshooting guide for abnormal furnace operation and interpretation of control error flash codes.
