2. Maintenance
The maintenance of emission control device or system is as follows.
1. Check the air filter element to
verify if it is blocked or turns
2. Verify the damage on the
surface of the air filter
Start device any abnormal sounds
Device cannot be started or hunt-
ing or igniter keeps firing the
1. Device runs with hunting or
The air intake holes been blocked
Review the speed on controller, if
Crankshaft position sensor
If generator runs steadily
Review the water temp on control-
If generator runs steadily
If generator runs steadily
If generator runs steadily
If it is with normal exhaust emis
Generator can be started and run
If the speed is 3600 RPM and fre
quency display 60HZ range
2. Any oil leakage, runs steadily
3. Any abnormal noise exists
Any foreign article in exhaust or
Device can be stated with enough
If Generator can be started