User's Information
REQUIRED FILTERS - DOWNFLOW
CABINET WIDTH FILTERQUANTITY & SIZE
17-1/2" 2 - 14" X 20" X 1"
21" 2- 16" X20" X 1"
24-1/2" 2- 16" X20" X 1"
DOWNFLOW/HORIZONTAL FILTER
DOWNFLOW (Vertical) FILTER TABLE
The Problem Solver
CARBON MONOXIDE POISONING HAZARD
DO NOT ATTEMPT TO CHANGE THE VENTING SYS-
TEM. FAILURE TO FOLLOW THE INSTALLATION AND
OPERATION INSTRUCTIONS FOR THE VENTING
SYSTEM'S OPERATION COULD RESULT IN CARBON
MONOXIDE POISONING OR DEATH.
A furnace is not a household appliance. It is complex
and requires professional maintenance and repair.
That's why attempts at "do-it-yourself' repairs on an in-
warranty unit may void the remainder of your war-
ranty.
Other than performing the simple maintenance recom-
mended in this manual, you should not attempt to
make any adjustments to your furnace. Your dealer will
be able to take care of any questions or problems you
may have. A periodic inspection of your furnace should
be made by a qualified service agency at the start of
each heating season.
In the event that electrical, fuel, or mechanical failures
occur, you should immediately turn the gas supply off at
the manual gas valve located in the burner compart-
ment. Also, turn off electrical power to the furnace and
contact a qualified service agency.
Keep your furnace looking like new for years.
Clean the enamel finish of your furnace with ordinary
soap and water. For stubborn grease spots, use a house-
hold detergent. Lacquer thinner or other synthetic sol-
vents may damage the finish.
Save time and money. Before calling for
Problem
No Heating --
Blower does not operate
Possible Trouble
1. Thermostat set incorrectly.
2. Blown fuse or tripped circuit breaker.
3. Burner does not ignite.
4. Main gas line turned off.
5. Blower door removed or ajar.
6. Lockout
service, check the following:
Possible Remedy
1. Adjust thermostat. See operating instructions.
2. Replace or reset protective device or call for servicer.
3. Call Servicer.
4. Have gas company check.
5. Close door securely to restore power to blower and gas
valve.
6. Turn power on-off-on-off twice in 30 seconds.
Insufficient Heating -- 1. Dirty air filters. 1. Clean or replace filters.
Blower operates continuously. 2. Blocked supply or return registers. 2. Make sure registers are open and no obstacles are blocking
off the air
Unusual Noise Call your servicer.
8 32-5035-05
To Next Page
Loading...
