Configuring Settings on the Home Screen
4 BAS-SVU040G-EN
• Temperature sensor failure: the space temperature sensor in use has failed. If the remote or wired sensor
was in use, the zone sensor switches to the internal temperature sensor for temperature control.
• Single touch of
or advances the setpoint value by one. Holding down or rapidly advances
through the available range of values.
• Temperature: displays either the current space temperatu
re or the
temperature setpoint currently being
used to condition the space.
• If configured to do so, the Home screen will revert to a blank standb
y screen after 2.5 minutes of user
inactivity.
• All settings are retained in sensor memory in the event of a power outage.
Configuring Settings on the Home Screen
Icon buttons displayed on the Home screen can be changed by selecting 1 of 3 available home screen
configurations. See the “Trane Commercial Touch Screen Programmable Zone Sensor Installation Guide,” BAS-
SVN028, for configuration instructions.
Cool/Heat System Mode Settings
• Off: the system will not cool or heat the space.
• Auto: the system switches between cooling and heating automatically to condition the space.
• Cool: the system will only provide cooling to the space.
• Heat: the system will only provide heat to the space.
Fan Mode
• Auto: the system fan runs only when there is a call for either cooling or heating.
• On: the system fan runs continuously in occupied mode. The fan runs only when there is a call for heating
or coolin
g in unoccupied mode.
Schedule Menu
Touch to access the Schedule Menu. From this menu the date/time, schedule events, and temperature
setpoints, can be adjusted. The Options sub-menu allows the user to override schedule con
trol and change the
schedule type.
Override
Touch to override/cancel occupancy mode, cancel temperature setpoint overrides, and exit/enter demand
shed mode.
Touch Button Legend
Return to Home screen.
Previous and Next screen advancement.
Change setting values.
To Next Page
Loading...