Whisper Wall Fan Heater - Models BHC & BHC SS
Ensure that the electricity supply is disconnected
from any relevant fixed wiring before commencing
the installation. Ensure that the mains supply voltage is as stated on the rating label. The supply circuit
must be adequate for the input of the appliance. This unit must be installed by a registered electrician. The
installation of this product must comply with NZS 3000.2007.
Thermostat
Control Knob
Inlet
Grille
Outlet
Grille
Switch
Pullcord
Neon
Indicator
whisper bathroom heaters
Available in
White (Code: BHC) and Silver (Code: BHC SS)
• This heater has been designed and manufactured to the highest international standard, but, like all other electrical
appliances which are operated by mains voltage, care must be taken if you are to obtain the best results and safety
is to be assured.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instructions
concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• The heater is to be installed so that switches and other controls cannot be touched by a person in the bath or
shower.
• The heater must not be installed in front of a socket-outlet.
• Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• Do not handle the appliance with wet hands.
• Do not use the appliance in workshops or rooms where excessive dust is generated or present.
• Ensure that nothing is pushed into any aperture of this appliance.
• Do not touch the outlet grill when the appliance is in use.
CAUTION
In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be
supplied through an external switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
Installation
The Whisper Wall Fan Heater is a metal bodied
heater ideal for bathrooms, kitchens and areas requiring
localised, controllable heat. The Whisper features
a variable thermostat, with a frost protection setting,
for increased economy, pullcord operation, automatic
overheat safety cut-out and a power-on indicator
light. For ease of installation it is fitted with a 0.9m
cable.
Features:
Thermostatic control • Pull-cord operation • Automatic
safety cut-out • Power-on indicator • Fitted power
supply cable • Fixing/Securing bracket • Finished in Crisp
White or Stainless • 190(h) x 115(d) x 300(w) mm
Safety
• The appliance should be fitted horizontally such that the cable entry is uppermost and
the pullcord is at
the bottom.
• The unit must be mounted a minimum of 1.8m from the floor, also a minimum of 150mm below ceiling level or
any other projecting surface. It must also not be less than 250mm from any adjacent projecting surface.
• The unit must not be located immediately below a fixed socket outlet.
• Ensure that when in use the airstream is not obstructed by a cupboard or similar object.
• Do not attempt to repair the heater or unscrew the outer casing yourself.
• Do not place aerosols or similar containers or materials susceptible to heat in the direct airstream.
To Next Page
Need help?
General