Restore Defaults
This function is available if you want to reset your Photo Frame’s settings. Note: All settings that have been
changed will return to the factory defaults.
1. Select Restore defaults from the Settings menu.
2. Use the
or buttons to highlight “Yes.”
3. Press to confirm.
4. After the process is finished, the Settings menu will be displayed again.
Upgrade Firmware
Use this function to keep your Photo Frame up to date with the latest version from Transcend (available on
the Transcend website.
1. Insert a storage device such as SD/SDHC memory card that contains a newer firmware version for
your Photo Frame.
2. Select Firmware upgrade from the Settings menu and press to start the firmware detection
process. Photo Frame will automatically find the new firmware file.
3. If Photo Frame finds that a newer version of firmware is available, a “Yes / No” selection message
will be shown. Press
or to select “Yes” and press to perform the system upgrade. If
you do not want to upgrade, press “No” to return to the Settings menu.
To Next Page
Loading...
