TransDeco TD600B - Step 5: Attach Wood Frame; Step 6: Install Pivoting Device; Step 7: Attach Mounting Bracket; Step 8: Install Shelving Supports

- Attach the wood frame to the main structure;
- Do not tighten the screws until all screws are in place;
- Align the wood frame and the main structure;
- Fasten all the screws including those on the back panel
and the top connectiong bar;
- Install the wire management clips (Part H).
- Install the pivoting device(Part X) to the mounting bracket(Part AA).
- Attach the mounting bracket to the main structure
as shown;
- Level the mounting bracket and fastern all the screws.
- Install Part M as shown;
- Affix the silicon (Part K) as shown;
- Install Part N as shown.