Trasam DAC2 - Connecting Headphones and Amplifiers; Connecting to a PC

power outlet by the supplied cable.
3. Press the DAC2 power switch to the ON position only when signal
connection is finished.
Connecting headphone
1. Be sure that the DAC2 power switch is in the OFF position
2. Plug the headphone into the DAC2 EARPHONE jack at back. A
adaptor
is needed if the jack size different.
3. Recommended to move off the headphone to protect your hearing
whenever turning the power on or off, although the DAC2 has
anto-mute function for muting the main outputs when headphones are
being used.
4. Turn the volume at the lowest level before turning on the power.
Connecting amplifier
1. Be sure that the power switches of both DAC2 and amplifier are in the
OFF position.
2. Turn the volume at the lowest level for both devices.
3. Connect the DAC2 LINEOUT jack to the amplifier input jack by audio
cable.
4. Turn on the power to your sound gear starting with the sources
(computers, CD players, etc.) and ending with the power amplifier or
speakers.
Connecting PC
Connecting PC via USB
1. Connect the DAC2 by supplied USB cable, plug into the computer
USB interface.
2. Select the input mode “USB”.
3. Windows will identity DAC2 as the USB audio device automatically.
4. Configure the USB audio device as the default on your computer
system.
5. Press the DAC2 power switch to the ON position.
6. Press the amplifier power switch to the ON position.
Connecting PC via Optical or Coaxial
5