www.tractorsupply.com For customer support call 1-888-376-9601 3 2
OPERATION
l Pull and turn the clutch knob, so the drum can turn freely by hand.
l Use hand saver bar to hitch the hook of the cable assembly and pull cable to the
load. Attach the cable hook to the load.
WARNING: Check that there are at least five turns of cable remaining on the drum
before operation. Ensure the clutch knob is in the engaged position.
CAUTION: Clutch must be fully engaged before winching.
Never operate the clutch while drum is turning. Do not readjust clutch knob as it has
been adjusted and permanently locked in place with a thread-locking compound in the
factory.
l Press the “IN” button on the ATV/UTV switch to re-spool the cable. Press the
“OUT” button to reverse directions. Wait until the motor stops before reversing
directions.
l Re-spool the cable after completing the operation.
REPLACING THE CABLE
l Engage the clutch by turning the clutch knob to the “ENGAGE” position.
l When inserting the cable into the drum, insert it into the correct end of the hole
provided. Tighten the screws.
l Operate the winch an re-spool the cable around the drum tightly.
CAUTION: To keep the stated tension, be sure the cable is wrapped on the drum
tightly.
WARNING: Always replace damaged cable with manufacturer’s identical
replacement part.
To Next Page
Loading...
