Travis Industries 564 DF GSR2

To Next Page

564 Diamond-Fyre

GreenSmart™ GSR2 Fireplace

• Operation

• Maintenance

Tested and Listed by

Report # 100884869PRT-001

ANSI Z21.88-2009/CSA 2.33-2009

WARNING: If the information in these instructions is not followed exactly, a fire or

explosion may result causing property damage, personal injury or loss of

life.

- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this

or any other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call gas supplier from a neighbor's phone. Follow the gas supplier's

instructions.

• If you cannot reach your gas supplier, call the fire department.

- Installation and service must be performed by a qualified installer, service agency or the gas

supplier.

This appliance may be installed in an aftermarket

permanently located, manufactured home (USA only)

or mobile home, where not prohibited by local codes.

This appliance is only for use with the type(s) of gas

indicated on the rating plate. A conversion kit is

supplied with the appliance.

Owner's Manual

www.travisproducts.com

4800 Harbour Pointe Blvd. SW

Mukilteo, WA 98275

Main Page

Other manuals for Travis Industries 564 DF GSR2

Installation Manual62 pages

Need help?

Do you have a question about the Travis Industries 564 DF GSR2 and is the answer not in the manual?

Summary

Introduction

Installation Warnings

Critical safety guidelines for proper installation by qualified professionals.

Safety Precautions

Gas Leak Response

Immediate actions if gas is detected, including evacuation and contacting authorities.

Flammable Item Placement

Avoid placing flammable items near the heater to prevent fire hazards.

Flammable Liquids and Operation

Service and Part Safety

Emergency Gas Shut-off

Instructing household members on how to shut off the gas supply.

Child and High Temperature Safety

Alerting to surface temperatures and supervising children.

Operation

Remote Set-Up

Steps to verify the switch and synchronize the transmitter to the IFC.

Accent Light Control

Remote Control Warnings

Low Battery Indicators

Operation

Continuous;Intermittent Pilot Switch

Explanation of pilot modes and when to switch between them.

Mode Controls (Flame, Blower, Light)

Adjusting flame height, blower speed, and accent light.

Battery Replacement Guide

Detailed instructions for replacing batteries in the battery holder and transmitter.

Switching Pilot Modes

Detailed steps using the remote to change pilot modes (IPI/CPI).

Flame Height Adjustment

Instructions for adjusting the flame height using the remote.

Blower Speed Adjustment

Operation

Thermostat Modes

How to cycle through and use Manual, Smart, and Standard Thermostat modes.

Maintenance

Yearly Service Procedure

Recommended annual inspection and maintenance steps for qualified technicians.

Troubleshooting Common Issues

Common problems, their possible causes, and solutions.

Maintenance

Accent Light Replacement

Glass Frame Removal and Installation

Crushed Glass Installation

Maintenance

Glass Cleaning Procedures

Grill Installation and Removal

Face Installation and Removal

Wiring Diagram Explained