Need help?Do you have a question about the Traxxas E Revo 5605 and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Motor | Titan 775 (modified) |
| Battery | 7-cell NiMH or 2S-3S LiPo (not included) |
| Transmission | Single-Speed |
| Radio System | TQi™ 2.4GHz Radio System |
| Drive Type | 4WD |
| Top Speed | 30+mph |
| Gear Pitch | 32P |
| Differential Type | Sealed |
| Chassis Type | Molded Tub |
| Top-Speed | 30+ mph (48+ km/h) with optional gearing |
| Chassis | Molded Tub |
| Drive System | 4WD |
| Servo | 2075 |
Contact information and resources for Traxxas technical support.
Explanation of icons used in the manual for warnings and tips.
Key safety considerations and operational guidelines for the model.
Instructions and precautions for handling and charging batteries safely.
Safety and operational advice for the electronic speed control.
List of tools and equipment included with the model.
List of tools and equipment that must be purchased separately.
Suggested optional tools and equipment for an R/C toolbox.
Instructions for applying decals to the model for customization.
Step-by-step guide on how to glue replacement tires to the rims.
Diagram and labels for the TQ radio transmitter controls.
Visual representation of the E-Revo's electronic wiring connections.
Diagram showing the EVX-2 electronic speed control wiring.
Guidance on selecting and using the correct batteries for the transmitter.
Definitions of key terms related to the radio system.
Step-by-step instructions for installing batteries in the transmitter.
Guide on how to properly install and set up the antenna for the radio system.
Recommendations for choosing and using the appropriate battery charger.
Instructions for installing battery packs into the E-Revo model.
Explanation of how battery compartments can be adjusted for different battery types.
Warnings and considerations for using LiPo batteries with the model.
Steps to remove the spring clip from the battery compartment.
Steps to install the spring clip into the battery compartment.
Information about the high-current connector and its importance.
Explanation of the controls and settings on the TQ radio transmitter.
Details on adjusting transmitter settings like trim and servo reversing.
Essential rules for operating the TQ radio system safely.
Procedures for checking and setting up the TQ radio system.
How to perform a range test to ensure proper radio system operation.
Technical specifications for the EVX-2 electronic speed control.
Diagram illustrating the wiring of the EVX-2 speed control.
How to adjust the transmitter for optimal ESC performance.
Steps for calibrating the electronic speed control with the transmitter.
Explanation of the ESC's thermal protection feature.
How to select different operating profiles and modes for the EVX-2 ESC.
Factors affecting the model's run time, including battery type and usage.
Advice on how to maximize the model's run time.
Guidelines for operating the model in wet environments and precautions.
Specific precautions for operating the motors in wet conditions.
Required maintenance procedures after running the model in wet conditions.
Recommended maintenance tasks for extended use or storage.
How to maintain the watertight seal of the receiver box.
Steps for removing the radio receiver from its box.
Steps for installing the radio receiver back into its box.
How to adjust the suspension springs and pre-load for optimal performance.
Details on spring rates, pre-load adjustment, and sag.
How to adjust the vehicle's ride height using push rods.
How to adjust pivot ball caps for proper suspension operation and reduce play.
Information on shock oil viscosity and its effect on damping.
Step-by-step instructions for replacing the shock oil.
Critical settings for optimizing E-Revo's alignment and performance.
How to adjust the toe-in or toe-out settings of the wheels.
How to adjust the static camber angle of the wheels.
Limits for toe and camber settings based on ride height configuration.
Guidance on front and rear suspension settings for optimal performance.
Adjustments for the transmission and considerations for wheels and tires.
Guidance on motor selection, gearing, and compatibility.
Details on the opposed motor mounting system and correct installation.
How to adjust the gear mesh to prevent stripped spur gears.
Information about the dual-servo steering system for responsive control.
Steps to adjust the dual-servo steering system for proper alignment.
Tuning the servo saver for optimal performance with different servos.
Optional modification to increase steering throw for sharper turns.
How to adjust the caster angle to influence handling characteristics.
How to adjust the roll center for improved handling and traction.
Explanation of rocker arms and their effect on suspension travel and rate.
Chart detailing outer toe link end positions to eliminate bump steer.
How to tune shocks by changing pistons for damping adjustment.
Details on shock piston sizes, disassembly, and assembly for tuning.
How to tune differentials by changing silicone oil viscosity.
Instructions for installing long travel rocker arms and springs.
Information about using brushless motors with the E-Revo.
Procedures for installing or replacing motors.
To Next Page