Need help?Do you have a question about the Traxxas Nitro Stampede and is the answer not in the manual?
Crucial warnings about fuel toxicity, flammability, and safe storage to prevent accidents.
Guidelines for safe handling, charging, and storage of rechargeable battery packs for longevity and safety.
Details on using Traxxas Top Fuel for optimal performance and engine longevity.
Explanation of radio terms, frequency bands, and channel identification for setup.
Comparison between NiCad and NiMH batteries, highlighting their characteristics and performance.
Procedure to ensure no other models are operating on the same channel before starting.
Correct sequence for powering on the transmitter and receiver to prevent loss of control.
Procedure to verify the radio system's effective range to ensure safe operation.
Charging and installing the EZ-Start battery and preparing the system for use.
Detailed steps for starting the engine using the EZ-Start system.
Adjusting high-speed, low-speed mixture, and idle speed for optimal engine performance.
Comprehensive guide to breaking in the engine, including fuel, adjustments, and duration.
Warnings about water damage to electronics and avoiding wet conditions.
Understanding low battery indicators and the implications for model control.
Guidelines on where to operate the model, avoiding night, public streets, and crowds.
Advice on radio interference and maintaining safety margins around the model.
Adjusting high-speed and low-speed fuel mixtures and idle speed for best engine response.
Adapting carburetor settings to environmental factors like temperature, humidity, and altitude.
Using temperature to fine-tune the engine, with guidelines on monitoring and avoiding overheating.
Adjusting toe-in and camber angles for optimal front and rear wheel alignment.
Information on shock pistons, springs, and oil for handling adjustments.
Adjusting gear ratios, slipper clutch, and clutch bell/spur gears for drivetrain performance.
Key maintenance tasks performed after hours of running, after sessions, and periodically.
Procedure to clear excess fuel when the engine is flooded and won't start.
Instructions on how to contact Traxxas for warranty claims and service.
Diagnosing and resolving common problems that prevent the engine from starting.
Identifying and fixing issues related to engine sluggishness, hesitation, or poor performance.
Resolving common problems such as engine stalling, overheating, and abnormal running.
Detailed steps for removing the engine from the chassis and its initial disassembly.
Procedures for removing the exhaust header, carburetor, backplate, and starter shaft.
Instructions on handling the piston and sleeve assembly during rebuild, including orientation marks.
Steps for removing the sleeve, connecting rod, piston, clutch, and flywheel.
Instructions for removing the crankshaft, cleaning bearings, and preparing components.
Steps for polishing and lubricating the crankshaft journal and wrist pin for longevity.
Assembling the connecting rod, piston, sleeve, and crankcase components.
Installing the backplate, clutch, flywheel, and reassembling the carburetor and engine.
Information about the Traxxas program for exchanging worn engines for new ones.
Details on upgrade kits for installing the TRX 2.5R Racing Engine into older models.
General| Scale | 1/10 |
|---|---|
| Transmission | Auto Two-Speed |
| Drive System | 2WD |
| Shock Type | Oil-Filled |
| Type | Monster Truck |
| Radio System | TQ 2.4GHz |
| Top Speed | 30+ mph (48+ km/h) |
| Engine | Traxxas 2.5 |
| Engine Model | Traxxas 2.5 |
To Next Page