TREBLAB Z7 PRO - ANC and Sound Modes; Managing Noise Cancellation and Ambient Sound

SETTING UP YOUR TREBLAB Z7 Pro
Turn ON
Press the POWER button for 3 sec. You will hear the sound
prompt and, a few seconds later, the “Bluetooth pairing on”
voice prompt. The LED on the right earcup will turn blue and
then will start flashing blue/red. In case the headphones have
been previously connected to the smart device, instead of
“Bluetooth pairing on”, you will hear the “Connected” voice
prompt and the LED will start flashing blue/green slowly.
Turn off
Press and hold the POWER button for 4 sec. You will hear the “Power
off” voice prompt. The blue LED will light up for a second and will go off.
Function
Enable Ambient
Sound mode
Enable ANC
Disable
Ambient Sound
and ANC modes
Awareness
mode
Operation
When ANC mode is on, press the ANC button
once.
When the ANC and Ambient Sound modes
are off, press the ANC button once.
When the Ambient Sound mode is on, press
the ANC button once.
When the headphones are turned on, close
the right earcup with a palm.