PAIRING
Make sure the TREBLAB Z7 Pro are charged and the 3.5 mm
audio cable is not plugged in.
Press the POWER button for 3 sec. You will hear the sound
prompt and, a few seconds later, the “Bluetooth pairing on”
voice prompt. The LED on the right earcup will turn blue and
then start flashing blue/red indicating that Z7 Pro are in the
pairing mode.
Activate the Bluetooth option on your smart device and
keep it within 3 feet/1 meter from the TREBLAB Z7 Pro
while pairing.
Scan/search for available devices in your smart device.
Select TREBLAB Z7 Pro from the device list.
If the password is prompted, enter "0000”.
Once the Z7 Pro are successfully paired and connected,
you will hear the “Connected” voice prompt, and the LED
will start flashing blue/green slowly.
You can unpair with the current device and enter the pairing
mode manually at any time by pressing and holding the
Bluetooth button for 3 sec.
1.
2.
3.
4.
5.
6.
To Next Page
Loading...
