3
Choose a good, cleared assembly area and get a
friend to help you put your feeder together. Lay
card board down to protect feeder finish and
assembly area.
Step 1
Install 2 AA batteries in back of timer. Set aside
for later use.
Step 2
Lay hopper on its side and attach motor
assembly to bottom of hopper using two M6 x
12 mm hex bolts. Connect motor assembly to
battery wire in plastic conduit.
Note: Feed wire connectors inside plastic
conduit.
3
2
1
FDR0350AS_OM.indd 4FDR0350AS_OM.indd 4 11/15/2022 1:21:54 PM11/15/2022 1:21:54 PM
To Next Page
Loading...