4
Step 3
Attach funnel plate to bottom of hopper
using four M6 x 8 mm bolts.
Note: Take extra care to protect solar panel
when laying hopper on lid.
Step 4
Slide spinner plate assembly onto motor
shaft and secure with one M6 x 12 mm hex
bolt. Align bolt with flat section of motor
shaft.
Note: Make sure spinner plate has a 1/8
inch gap between the plate and funnel
plate. (See illustration)
Flat Section
1/8 inch
FDR0350AS_OM.indd 5FDR0350AS_OM.indd 5 11/15/2022 1:21:54 PM11/15/2022 1:21:54 PM
To Next Page
Loading...