3
Choose a good, cleared assembly area
and get a friend to help you put your
feeder together. Lay card board down to
protect feeder finish and assembly area.
Step 1
Install 2 AA batteries (included) in
back of timer. Set aside for later use.
Note: Make sure to use only alkaline
batteries and to replace both batteries
at the same time. Do not mix old and
new batteries.
Step 2
Lay hopper on its lid and attach feeder
tube assembly to bottom of hopper
using four M6 x 15 mm hex bolts, M6
lock washers, M6 washers and rubber
washers.
Note: Take extra care to protect solar
panel when laying hopper on lid.
OM_FDRP600AS.indd 4OM_FDRP600AS.indd 4 3/25/2024 10:03:01 AM3/25/2024 10:03:01 AM
To Next Page