TREEPOD STAND INSTRUCTION MANUAL - ENGLISH
4. Turn the Topper over so it is standing
upright on the legs.
4
5. Tip the partially assembled
unit on two of its supports and
slide the male end of a Middle
Leg Pole into the female end
of a Top Leg Pole. Insert bolts
through the pre-drilled holes
from the inside. Place a washer
and lock washer onto the bolt
from the outside. Then screw
on a nut cap. Tighten using the
wrench to secure. Repeat with
the other two Middle Leg Poles.
5
6
6. Tip the partially assembled unit on two
of its supports and slide the male end of
an Adjustment Pole into the female end
of a Middle Leg Pole. Insert bolts through
the pre-drilled holes from the inside. Place
a washer and lock washer onto the bolt
from the outside. Then screw on a nut
cap. Tighten using the wrench to secure.
Repeat with the other two Adjustment
Poles.
OPTIONAL: Adjustment Poles can be removed for a lower overall height.
7. Tip the partially assembled
unit on two of its supports and
slide the male end of a Base Leg
Pole into the female end of an
Adjustment Pole or Middle Leg
Pole (if Adjustment Poles are
removed). Insert bolts through
the pre-drilled holes from the
inside. Place a washer and lock
washer onto the bolt from the
outside. Then screw on a nut
cap. Tighten using the wrench to
secure. Repeat with the other two
Base Leg Poles.
7
NUT CAP LOCK WASHER WASHER
NUT CAP LOCK WASHER WASHER
NUT CAP LOCK WASHER WASHER
To Next Page
Loading...