treesse Zen Pro - Page 19

19
Zen Pro minipool
EN
First run
6
“OK”
If pressed for more than three seconds you access
a submenu page where other system functions are
available (empty, manual backwash, keypad lock,
SILENCE mode).
When accessing special functions, the "KEYPAD
LOCK" icon is always lit by default.
To scroll through the various functions, press the "+"
and "-" keys. When the icon of the desired function
lights up, press the "OK" key to activate it.
After six seconds of inactivity the display exits
the submenu and returns to showing the water
temperature.
7
KEYPAD LOCK
Activation of this function will not allow the tempera-
ture set point to be changed, while the whirlpool,
blower and chromatherapy functions will remain
active.
To activate it:
A
Press the "OK" key
6
for at least three seconds.
B
this provides access to a submenu page.
C
The icon “KEYPAD LOCK”
9
is illuminated, press
the “OK” key
6
to activate it.
When the function is activated, the display will show
the word "LOCK" for six seconds and then return to
showing the water temperature.
To disable the function, press the "OK" key again for
three seconds and then press the "KEYPAD LOCK"
key
7
again.
8
EMPTY
The emptying of the minipool can be activated at
any time.
To activate it:
A
Press the "OK" key
6
for at least three seconds.
B
this provides access to a submenu page.
C
Use the
+
and
-
keys until the “EMPTY”
8
icon is illuminated and press the “OK” key
6
to
activate it.
The display shows the icon throughout the
entire emptying operation.
Emptying lasts 120 minutes and for the entire
duration the bathtub needs to be powered to allow
it to completely drain all residual water from the
tank pipes and lter. During emptying, the blower is
automatically activated to drain the airpool system
pipes.
During emptying of the minipool, the only enabled
function is chromatherapy.
To stop the emptying test, disconnect the power
supply to the bathtub for about 30 seconds.

OK
OK
3”
1
8
7
9
10
2
5
3
6
4
Submenu
page
Main page