Trek 2023 FX+ - E-system components and routing; Before removing the rear wheel

2023 FX+ / Dual Sport+
3
E-system components and routing
6
6
T30
6 Nm.
T30
T20
7
3 Nm.
6 Nm.
T20
3 Nm.
7
8
2Nm.
9
10
2 Nm.
11
14
13
12
11 Nm
13
11 Nm
1
2
3
4
5


T10
1
Hub motor – W5266204
2
Remote – W5260746
3
Torque sensor – W5257770
4
Controller – W5252986
5
Battery – W5255878
6
T30 drive bolts (M6x8 mm) – W5258222
7
T10 drive bolts (M4x6mm) – 5269023
8
T10 drive bolts (M3x8 mm)
5284384
9
Bottom bracket cover
10
Cable guide
5284388
11
Cable guide bolt (M4x6 mm)
12
Anti-rotational ange nut
5288641
13
Axle bolt
14
Charge port cover – W5263927
Before removing the rear wheel
1. Shift to the smallest rear cog (highest gear).
2. Unplug the motor cable at the chainstay.
3. Remove the cable-guide bolt (11).
4. Remove both axle bolts (13) and ange nuts (12).
Wiring diagram
NOTE: Light wiring diagrams are on pages 10-11.
1
2
3
4
5