2023 Domane SL/SLR
16
IsoSpeed: install parts
NOTICE: Do not perform routine maintenance on the IsoSpeed. Only service IsoSpeed hardware if you are replacing parts.
IMPORTANT: Clean all parts before reinstalling them using 50/50 isopropyl/water mix.
1. Grease the wedge assembly as shown below.
2. Assemble the tongue assembly (see page 14) and in-
sert it into the frame. Insert and torque the bolt (11).
11
6.8 Nm.
3. Apply threadlocker to the pivot bolt (5) and nut (6)
threads.
5
6
4. Place the wave washer (2) on the pivot bolt (5) and
apply grease as shown below.
NOTE: Do not apply grease to the frame pockets or
bushings. The grease could contact the pivot bolt
threads.
2
6
5
5. Install the nut (6) and pivot bolt (5). Torque the bolt to
10.5 Nm.
5
10.5 Nm.
6
To Next Page
Loading...
