TrekStor W1 - Performing a System Backup

EN
22
14) Performing a system backup
To enable a system recovery (including all data) in the event of failure, the MiniPC
allows you to make a "system image backup". We recommend performing the
backup using an external hard drive. To do so, proceed as follows:
a) Connect an external hard drive to the USB 2.0 port on the MiniPC
using a USB cable.
b) Open the Charm Bar.
c) Click "
settings
" in the Charm Bar.
d) Now click "
Change pC settings
" in the bottom-right area.
e) Click "
Control panel
" in the bottom-left area in the device settings.
The Control Panel opens.
f) Click "
File history
" in the Control Panel.
g) Click "
system image BaCkup
" in the bottom-left area of the following window.
The MiniPC asks whether you would like to save the backup.
h) In this window, select (highlight) the item "
on a harD Disk
", and in the
drop-down window directly beneath, select the connected external
hard drive as the target drive for saving the system image.
i) Confirm by clicking "
next
" in the bottom-right area of the window.
The MiniPC shows which drives will be backed up. Confirm by clicking
"
start BBaCkup
".
The system image is created and stored on the hard drive.