TREND IQView8 - Installation Instructions Manual

IQView8 Installation Instructions TG201232 Issue 2, 01-Aug-2012 1
Installation Instructions
IQView8/
Touch Screen Display
Important: Retain these instructions
These instructions shall be used by trained service personnel only
If the equipment is used in a manner not specied by these instructions, the protection provided by the equipment may be impaired.
1
Dimensions
3 INSTALLATION
1 UNPACKING 2 STORING (Altitude: <2000 m (6562’))
It is recommended that the installation should comply
with the local electrical safety installation practices (e.g.
HSE Memorandum of Guidance on Electricity at Work
Regulations 1989, USA National Electric Code).
CONTENTS
1 Unpacking .....................................................................1
2 Storing ...........................................................................1
3 Installation .....................................................................1
3.1 Installation - Mounting ...................................................1
3.2 Installation - On a Wall ..................................................4
3.3 Installation - In a Dry Partition Wall ..............................6
3.4 Installation - Power up ...................................................8
3.5 Installation - Wiring .......................................................9
3.6 Installation - Connect Cables ......................................10
4 End User Licence Agreement .....................................12
5 Cleaning and Maintenance .........................................12
6 Disposal .......................................................................12
WARNING Do not attempt to open the unit. Failure to
comply may cause damage to the unit.
HO
2
+70 °C
(158 °F)
0
-20 °C
(-4 °F)
85 %RH
up to 40
°C (104
°C)
IQVIEW8 SURFACE MOUNTING BOX (Surface Mounting)
230.0 mm (9.05")
255 mm (10.02")
37.7 mm
(1.48")
90 mm (3.54")
175 mm (6.9")
30 mm
(1.19")
48 mm (1.88")
239 mm (9.42")
202.5 mm (8")
243.5 mm (9.6")
46.5 mm (1.83")
IQView8 (with mounting brackets)
continued over page
IQView8 Installation
Instructions (TG201232)
3.1 Installation - Mounting
Labels used on IQView8
Service button
10 987
RX+RX- TX+ TX-
Connector for Trend current loop network
654
CNONC
Connector for relay output
Memory card slot
A
USB A connector
RS232
RJ11 (FCC68) connector for RS232
connection
Ethernet connector
24 Vac/dc
Connector for 24 Vac/dc input power.
AC power line return