Need help?Do you have a question about the TRENDnet TI-RP262i and is the answer not in the manual?
Step-by-step guide for mounting the switch on a DIN-rail.
Instructions for connecting power supplies and SFP modules.
Guide to connecting and using the switch's CLI for management.
Instructions for accessing the switch via its web-based GUI.
Setting the switch's IP address, subnet mask, and default gateway.
Manually configuring static MAC address entries.
Setting up port mirroring for network traffic monitoring.
Explanation of Quality of Service for traffic prioritization.
Configuring 802.1p, DSCP, and queuing algorithms for QoS.
Enabling and configuring IGMP snooping for multicast traffic.
Configuring port isolation and 802.1Q VLANs for network segmentation.
Configuring DHCP options and relay agent for IP address assignment.
Configuring Ethernet Ring Protection and Link Aggregation.
Enabling and configuring loop detection to prevent network loops.
Understanding PoE features and managing the power budget.
Configuring PoE globally and per port, including priority and scheduling.
Explanation of STP/RSTP and switch port operational states.
Configuring STP/RSTP timers, priority, port settings, and modes.
Saving, uploading, and downloading switch configurations.
Upgrading the switch firmware.
Resolving issues when the management page is inaccessible.
Step-by-step guide for mounting the switch on a DIN-rail.
Instructions for connecting power supplies and SFP modules.
Guide to connecting and using the switch's CLI for management.
Instructions for accessing the switch via its web-based GUI.
Setting the switch's IP address, subnet mask, and default gateway.
Manually configuring static MAC address entries.
Setting up port mirroring for network traffic monitoring.
Explanation of Quality of Service for traffic prioritization.
Configuring 802.1p, DSCP, and queuing algorithms for QoS.
Enabling and configuring IGMP snooping for multicast traffic.
Configuring port isolation and 802.1Q VLANs for network segmentation.
Configuring DHCP options and relay agent for IP address assignment.
Configuring Ethernet Ring Protection and Link Aggregation.
Enabling and configuring loop detection to prevent network loops.
Understanding PoE features and managing the power budget.
Configuring PoE globally and per port, including priority and scheduling.
Explanation of STP/RSTP and switch port operational states.
Configuring STP/RSTP timers, priority, port settings, and modes.
Saving, uploading, and downloading switch configurations.
Upgrading the switch firmware.
Resolving issues when the management page is inaccessible.
To Next Page
General