Video Setup Page
You can change the video setting: brightness, contrast, hue,
saturation.
Audio Setup Page
The function is use to select standby setting: OFF, 3 HOURS,
4 HOURS
OFF: No standby
3 HOURS: No remote control and panelkey operation within three
hours into standby
4 HOURS: No remote control and panelkey operation within four
hours into standby
AUTO STANDBY
OFF
3 HOURS
4 HOURS
BRIGHTNESS
CONTRAST
HUE
SATURATION
SHARPNESS
12
10
8
6
4
2
0
8
6
4
2
0
12
10
8
6
4
2
0
+6
+4
+2
0
-2
-4
-6
12
10
8
6
4
2
0
1
1
STANDBY SETTING
VIDEO SETUP
1
1
Item
Standard requirement
Electronical parameters
Power requirements
: AC 100-240 V , 50/60 Hz
Output
VIDEO OUT
AUDIO OUT
:1.2 Vrms (1 KHz, 0 dB)
Power consumption
Operating humidity
: <10W
: 5 % to 90 %
System
Laser
:Semiconductor laser, wavelength 650 nm
Signal system
: NTSC / PAL
Frequency
response
Signal-to-noise ratio
:More than 80 dB (ANALOG OUT connectors only)
Dynamic range
:More than 85 dB (DVD/CD)
Note: Design and specifications are subject to change prior notice.
: 20Hz to 20 kHz(1dB)
Battery Parameters
Battery Specifications:
Output:7.4V
Charge / Discharge Time:
Standard charge time:3h ~ 4h
Storage and work circumstances:
1. Storage circumstances Temperature Humidity
2.Work circumstances Temperature Humidity
6 months
-20 C +45 C~
-20 C +65 C~
65+20%
65+20%
Standard charge
Standard discharge
0 C +45 C~
-20 C +65 C~
65+20%
65+20%
1 week
PRECAUTIONS FOR CORRECT
DISPOSAL OF THE PRODUCT.
Thesymbolshownontheequipmentindicatesthat
waste must be disposed of in “separate collection”
and so the product must not be disposed of together
with urban waste.
Theusermusttaketheproducttospecial“separatewastecollectioncentres”providedbylocalgovernment,
or deliver it to the retailer against the purchase of a new product.
Separatecollectionofwasteandsubsequenttreatment,recyclinganddisposaloperationspromotesthepro-
ductionofequipmentwithrecycledmaterialsandlimitsnegativeeffectsontheenvironmentandonhealth
causedbyimproperhandlingofwaste.
Illegal disposal of the product leads to the enforcement of administrative penalties.
INFORMATION NOTE ON THE REMOVAL AND DISPOSAL OF BATTERIES
Warning: Only high-qualified personnel should perform this operation!
BATTERY REMOVAL
The appliance should not be plugged to the mains socket when performing this operation!
1. Remove the screws tightening the lower part of the appliance;
2. Selectthebatteryanddisconnectandremovethebattery.
Used batteries should not be disposed of with household waste or thrown into fire or water.
Usedbatteriesshouldberecycledordisposedofinseparatewastecollectioncentres.