To Next PageTo Next Page
Need help?Do you have a question about the Trevi XT 108 BT and is the answer not in the manual?
General| Brand | Trevi |
|---|---|
| Model | XT 108 BT |
| Category | Speakers |
| Type | Portable Bluetooth Speaker |
| Connectivity | Bluetooth |
| Card Reader | Yes |
| USB port | Yes |
| Power Source | Battery |
| Waterproof | No |
| Dimensions | 180 x 70 x 70 mm |
Identifies and describes the controls and ports located on the main speaker unit.
Details the input/output sockets and power connection on the rear of the unit.
Covers buttons for adjusting volume, audio settings, muting, and powering the device on/off.
Details buttons for media playback, track skipping, mode switching, and source selection.
Procedure for turning the audio system on and off using the unit or remote.
How to switch between different audio input modes like Bluetooth, FM, USB, and AUX.
Instructions for raising the audio output level using unit or remote controls.
Instructions for lowering the audio output level using unit or remote controls.
How to temporarily silence the audio output and then restore it.
Procedure for automatically scanning and saving available FM radio stations.
Guidance on inserting USB memory drives and formatting requirements.
How to activate the USB playback function on the unit.
Using buttons to play, pause, and resume audio tracks from USB.
Selecting the next or previous track from the connected USB device.
Setting options for repeating a single track or all tracks in the USB library.
Steps to enable Bluetooth, search for devices, and pair with the audio system.
Managing audio playback from a connected Bluetooth device.
Skipping to the next or previous track wirelessly via Bluetooth.
How to connect external audio devices using the AUX-IN port.
Activating the audio input from an external source.
Using the connected device's controls for playback management.
Steps to resolve problems where no audio output is produced.
Checks to perform if the unit fails to turn on.
Solutions for when the device does not react to commands.
