SELECTING CONTACT POINT LENGTH
(Does Not Apply to Classic 70)
Your Remote Trainer comes with two sets of contact
points – long and short.
The shorter points are installed in the unit at the factory and
are suitable for most coat lengths. For dogs with especially
long hair or thick undercoats, the long contact points will
give the best possible contact.
To change the contact points, always use the small wrench
supplied with your Remote Trainer. Avoid using tools which
may cause you to over-tighten the contact points.
Periodically check contact points for tightness.
T R I - T R O N I C S
Selecting Contact Point Length
Insert screw-in contact points as shown and only tighten with
the small wrench supplied with the Remote Trainer. Do not
over-tighten. Check contact points periodically for tightness.
Selecting Contact Point Length Page 9
To Next Page
Loading...
